Unplug batterySlide Master to MAXPlug in battery, wait for beeps. remember, you should have removed props at the start, if you didnt, DO THIS NOW.

Green = mode activated, grey means Acro/Rate mode.Now we need to calibrate ESC, go to the motor tab. If you have more than six channels you may want to setup ARM as a switch, as well as a buzzer, or lights.Now save your settings.īy moving your switches you should be able to test the setup. You want to set up your AUX Switches, open the Modes Tab.No mode selected = ACRO+ / Rate mode by default.Altitude mode = Angle Mode Rattitude mode = Horizon Mode If you your switch only has two positions it would look something like this.0 = Horizon Mode 1 = Acro/RateIf you have a switch that has 3 positions it may look like this.

RC rate to 1.00, RC expo 0.00 – SaveNow.

Ch 1 moved to Ch3 Ch 3moved to Ch 5 Ch 4 moved to Ch 1 Ch 5 moved to Ch 4 (You may need to swap Ch 2 and Ch 4 around if your pitch and roll is incorrect. I have the Avionic receiver, so for me, I had to move the following.Now goto receiver tab, and check all your transmitter channels are correct, they usually are different and you will need to reconfigure.Click Save and rebootNow goto your PID tuning.Change PID Controller to LUXFloat.Change minimum throttle to 50 above what your receiver shows on Receiver tab.To connect your Quad to Cleanflight you always need to use power now, plug in your battery!Place Quad on flat surface and under setup, click calibrate accelerometer.Open cleanflightPower your Quad and plug usb back in now.IMPORTANT! Leave USB plugged in and power the board via esc inputClick boot (in same firmware window), motors will beep and wait till blue light on the cc3d is steadily blinking.Click the checkbox, I know what I’m doing!.Click rescue then plug in your Quad to computer via USB (no power)Click open and select.On openpilot and open the firmware tab.For difference on Cleanflight vs Betaflight view this article.bin file – so thats why we have put Cleanflight 1.10 ONLY, versions after this do not have. bin or Latest Betaflight CC3D BIN File from Install the Cleanflight Configurator from the Chrome Web Store.Download Cleanflight 1.10 firmware.Download OpenPilot GCS 15.02.02, You may also need the STM32 Virtual Com Port driver.If, you flip the cc3d board you can see a micro usb connection on the cc3d.After connecting the usb to your pc, it might ask you to download drives,then do it.

Flight controller upilot